Masking Compound, Masking Compound Manufacturer, Masking Compound Supplier, Mumbai, India

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

PVC Dip Mouldings, Valves, Tools, Sleeves Plastic, Rubber Rollers, Tools Accessories
 

Masking Compound

 
Description :
Masking Compound is an air drying organosol, which finds use for masking the area of metal parts that are not to be electroplated.  It has sufficient adherence to enable it to withstand plating cycles, but is easily peeled off after it has served its purpose.  It is suitable to use in chromium and other plating processes.
 
Technical Specifications :
Type
:
Organosol
Colour
:
Gray
Viscosity ( Ford cup No. 4 at 30 deg. (C)
:
90 to 110 Seconds
Typical film thickness
:
40 ti 60 microns
Drying Time  :
a) Surface dry
b) Hard dry
c) Forced drying

:
:
:

20 to 30 minutes
60 to 120 minutes
80 deg. C for 5 to 10 minutes.
Thinner recommended
:
M.C. Deluter.
 
Application :

Masking Compound can be applied by brushing / spraying / dipping.  Apply two more coats depending upon article involved, where sharp edges are present, extra coats are recommended.  In brushing, use a full brush and avoid repeated back and forth brush strokes, which may result in thin spots.  Allow each dip or brush coat to dry for 5 to 10 mins.  Air dry the final coat for minimum 1 hour before plating to achieve best results.  If the masking was overlapped an areas which are to be plated, cut the coating with a sharp knief at the plating line and peel it off where it has overlapped.  Avoid any tearing action which may loosen the coating from adjacent areas.

For spraying, use M.C. Deluter to adjust the viscosity.

 
Packing :
20 liters containers
 
Storage :
Organosols have tendency to thicken ( increase in viscosity ) on standing and therefore should be stored in a cool and dry place. Always keep the lid tightly closed after use.
 
Shelf Life :
Six months under normal temperature conditions.
 
Precautions :
Making Compound contains volatile ingredients. Hence not to be used be near flame or heat.
 
Note :
It should be appreciated that the information given here is to the best of our knowledge, true and accurate. However, since conditions under which our products are used are beyond our control, recommendations are made without warranty of guarantee.
 
 
 
PVC Caps   |   Rectangular Cap And Taper Cap    |    PVC Grips    |   PVC Sleeves    |    PVC Shrouds   |   
PVC Covers    |   PVC Coating Work    |   Plastic End Caps    |   Plastic Protective Caps
 
 
Home    |    Profile    |    Introduction    |    Products    |    Contact    |    Enquiry
Designed & Hosted By : MID     Promoted By : GID